Speaker Cable Loss Calculator

Speaker Cable Loss Calculator

Enter each cable run: speakers on the channel, distance from the amp to the speaker, and wire size. It shows the loss in the cable and how much power it costs.

Project

Saves your cable runs and settings to a file you can open again later.

Import amp setup opens a file saved from the Amp-to-Speaker Matching Calculator and makes one cable run per amp channel, with the speakers, quantity and impedance setting filled in. You add the distances.

Settings

Cable loss: 0.5 dB ≈ 11% of the power, 1 dB ≈ 21%, 3 dB = half. Damping factor is worked out for subwoofer runs; enter the amp's spec and the load it's quoted at, or leave it blank to count only the cable.

Type part of a model name to filter the list. Variants like KV25R II or KP52W I find their base model automatically. Pick "Custom load" for anything not in the list.

How it works
  • Load is the speaker's impedance setting divided by the number of speakers in parallel on the channel (3 × 16Ω = 5.3Ω).
  • Cable resistance counts both conductors, out and back (2 × the distance to the speaker), for copper at 20 °C. mm² sizes use the IEC 60228 Class 5 (flexible) maximum resistance.
  • Loss is how much quieter the speakers get because of the cable: 20·log(load ÷ (load + cable)). Power lost is how much less power reaches the speakers than with no cable resistance, the same convention as published wire-loss charts (0.5 dB ≈ 11%, 1 dB ≈ 21%, 3 dB = 50%).
  • Damping factor (subwoofer runs only) is the load ÷ (amp output impedance + cable resistance). The amp's output impedance is the load its DF is quoted at ÷ the quoted DF (DF 500 at 8Ω = 0.016Ω). With no amp DF entered, only the cable counts, so the real figure is a little lower. A common minimum target for live sound is about 20.
  • Distance to speaker is the one-way distance from the amp to the speaker, not the total length of wire; both conductors are counted for you.
  • Daisy-chained: enter the distance from the amp to the farthest speaker. The whole load is treated as if it were at the end of the cable, which is the worst case.
  • Home runs: each speaker has its own cable back to the amp. Enter the distance to the farthest one; the cable totals multiply by the quantity.
  • Loss colors: green under the yellow-flag level (1 dB by default), yellow above it, red (fails) above the red level (3 dB by default, half the power).
  • Uses nominal impedance. Real speaker impedance changes with frequency, and 70V speakers aren't covered.
Copper conductors at 20 °C and nominal speaker impedance. Results are estimates; always confirm against the project's cable schedule.